Simple Raspberry Pi touch screen case

This is a simple case for a Raspberry Pi (any version) with the LCD touchscreen from the Raspberry Pi Foundation. Parts needed: 4 x 3mm thread inserts 4 x screws for the LCD screen 4 x M3x6mm screws (back lid) The screws can be welded to the included knobs, or flat head screws can be used. Print settings and instructions: Easy to print, without supports. If printing in higher speeds, use a small brim to avoid warping with the big flat pieces. All parts can be printed without support, using the correct orientation. Screen frame: print with the flat side to the bed. Case: print with the tabs touching the bed. Back lid: print with the tiny screw chamfers facing up. Stand: print facing up, with the flat grid to the bed. Infill: from 8% to 15% is enough. Grid pattern fits better with the flat top layers. Suggested 3 walls and at least 3 top and bottom layers. Ironing can make the back lid look better. The other parts do not exposed top layers. Assembly: Put the LCD screen into the frame Ali