Simple Sneaker

Materials needed:
Prints of three files provided
Shoelaces or a shoelace-length piece of ribbon, thread, or similar material

Optional materials:
Pliers
Sandpaper


Print sneakerback.stl oriented such that the sole is centered on the base of the printerbed.

Print sneakerfront.stl so that the flat face at the front of the sole is face down on the center of the printerbed.

Print sneakertongue.stl oriented using these rotate settings: X: -166 degrees, Y: 92 degrees, Z: 14 degrees

Print all files with the following settings:

Supports: On

Infill: 20%

Layer thickness: .2 mm

Shell thickness: .8 mm

After printing, remove supports (a pair of pliers makes this easier). Sand and paint as desired. Connect the front and back of the shoe by pressing the tab on the front sole into the slot on the back sole.

Using thread, ribbon, or the shoelace you intend to use on this shoe, stitch together the 4 holes on the tongue to the 4 holes on the front half of the sneake