Thingiverse
Simple Tacoshell holder
von TheBoredPrinter
1
Downloads
1
Likes
0
Makes
A simple taco shell holder with place for two taco shells.
Supports could be needed, depending on in which position you print it. You can use a raft but it's not needed, I used supports instead(Yes I know I'm stupid).
I used PLA filament and I wish you ABS or other plastic users good luck.
Enjoy your taco-Friday!
Supports could be needed, depending on in which position you print it. You can use a raft but it's not needed, I used supports instead(Yes I know I'm stupid).
I used PLA filament and I wish you ABS or other plastic users good luck.
Enjoy your taco-Friday!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
