Slicer Discord
Simple wall clock – 3D-Druckmodell von MakerWorld MakerWorld
Decor

Simple wall clock

von maxior76 · Decor
152 Downloads
93 Likes
38 Makes
Zum Modell
Use your wall as a clock face!A simple, yet powerful addition to any household. It will most likely change the way you look at your room! It's a clock and a nice decoration in one.Clock consists of 15 digits and a mechanism cover. Mounting can be a little tricky, so I added digit stencils (for 10, 11 and 12) as well as kind of a protractor. Those additional objects are thin (2mm), so not much material will be used on them, but those help a lot! Protractor has also kind of an “ear” on top - it marks a place where mounting hole of cover will have to be, to maintain holes alignement - mark it and attach your wall hanger so the top sits there. I have used double sided tape for mounting the digits and a plastic hook with three nails (invisible hook) for mechanism cover. For less permanent fixture you can use sticky putty.Plastic “fake nail” is attached too, so you can use it instead of nails.For the clock mechanism I have used mechanism extracted from an old clock, arms weren't chan
Kategorie
Decor
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen