Thingiverse
simple wall hook
door da_syggy
84
Downloads
54
Likes
0
Makes
I wanted a simple, small but sturdy and somewhat stylish wall hook I can print in different colors for my kids clothes and stuff.
After looking around a bit I didn't find a hook that I really liked, so tried designing my own.
To get maximum strength print it on its side.
When printed on its side **be careful not to overtighten the screw**, you'll risk splitting the hook. Use a screwdriver and no powertools!
I used 25x2.5 screws to screw them into wood. Use longer screws (diameter 2.5mm max.) and dowels when screwing directly onto the wall.
**prints in less then 20 min!**
After looking around a bit I didn't find a hook that I really liked, so tried designing my own.
To get maximum strength print it on its side.
When printed on its side **be careful not to overtighten the screw**, you'll risk splitting the hook. Use a screwdriver and no powertools!
I used 25x2.5 screws to screw them into wood. Use longer screws (diameter 2.5mm max.) and dowels when screwing directly onto the wall.
**prints in less then 20 min!**
da_syggy publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
