Thingiverse
Single Piece Stackable Brio Riser
von dalgibbard
247
Downloads
116
Likes
8
Makes
Remixed the Brio bridge from theinternal - I liked the arched design, and the matching stackable-ness of the original Brio pieces; but wasn't keen on having to print multiple pieces and assemble with screws.
Designed this alternative; print with the top of the track touching the print bed (upside down), and supports on print bed enabled - there's only a small amount of support surface area needed here, but prints as a single piece with no assmebly required. It doesn't have the cool top arch anymore, but it's still practical :)
Designed this alternative; print with the top of the track touching the print bed (upside down), and supports on print bed enabled - there's only a small amount of support surface area needed here, but prints as a single piece with no assmebly required. It doesn't have the cool top arch anymore, but it's still practical :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
