Skyline Light Diffuser Pieces

These are the model files for a project I recently completed.

To complete this project you'll need:
* A place to hang them with a light source behind it. I built a frame around mine as well.
* 1/16" steel cable and eye screws to hang the pieces.
* Magnets (10mm diameter)

Instructions:
1. Use 1/16" steel cable to create however many rows you will make, use eye screws spaced 4" apart at the ends and secure it so it's not too loose.
2. Print a bunch of cubes. I used basic translucent PLA using "Lightning" infill, tuning density to how I wanted it to look. I only had 1 perimeter using .5mm line width. I printed on a glass bed to try to get as much clarity I could out of the bottom layer.
3. Glue magnets to each cube and each hanger piece.
4. Clip hanger pieces on a row, hang cubes from hanger pieces.
5. Once a row is perfectly spaced, drop a bit of glue (I used elmers) on where the hanger pieces and steel cable touch so it doesn't slide around and cause bunching.
6. Repeat for as many ro