Thingiverse
sliding container
von SebasKat
0
Downloads
0
Likes
0
Makes
ok first of all do not judge the object on its appearance yes i know it looks kind of goofy but its very very useful so be sure to try and print it out .
printing settings are, you need support and put the infill at around 40 to 50 procent ,everything else, is up to you .
hope you enjoy !
printing settings are, you need support and put the infill at around 40 to 50 procent ,everything else, is up to you .
hope you enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
