Slicer Discord
Small Rectangular Funnel  – 3D-Druckmodell von Thingiverse Thingiverse

Small Rectangular Funnel

von thanekew
12 Downloads
13 Likes
0 Makes
Zum Modell
I needed a small funnel to load my keyring bottle with Slap Ya Mama Seasoning. The funnels that I saw online were usually round and too large.

This funnel is wide so that a seasoning container can pour into it and small enough to fill a small container (shown in images). Also, it is rectangular and won't roll around in the cabinet.

The wall is 1.25 mm. Print with a brim. No support needed.

I sand them down on the inside and spray epoxy to seal them.
Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 2/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Schleifen, Kleben
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen