Thingiverse
Snapmaker bed level test
von PrintShed
43
Downloads
19
Likes
0
Makes
My version of a bed level test specifically designed to suit a Snapmaker V1's bed.
A couple of recommended settings;
1) 0.4 nozzle
2) 0.3 initial layer height
3) Concentric bottom pattern (Cura)
4) No skirts, brims of rafts
This should give a single layer print with a single line border and 20 lines within the pattern to ascertain if the bed is level and flat.
A couple of recommended settings;
1) 0.4 nozzle
2) 0.3 initial layer height
3) Concentric bottom pattern (Cura)
4) No skirts, brims of rafts
This should give a single layer print with a single line border and 20 lines within the pattern to ascertain if the bed is level and flat.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
