Thingiverse
Snapstack
von petolone
18
Downloads
14
Likes
0
Makes
"Snapstack" is a snap-on corner piece to make the Battery Cases by 3DBagster stackable. The idea is to have it snap-on maybe even without any glue. [I must admit though the few drops of CA glue was indeed needed, but is not a big deal.]
Both AA and AAA versions are now provided
1. snapstack_AA.stl
2. snapstack_AAA.stl
(Load the cases themselves from the original thing.)
Both AA and AAA versions are now provided
1. snapstack_AA.stl
2. snapstack_AAA.stl
(Load the cases themselves from the original thing.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
