Thingiverse
SnapTite Dice Tower (Basic)
door RawData73
5
Downloads
9
Likes
0
Makes
Here's a basic dice tower. Prints in two halves and snaps together (provided your FDM printer can print in tight-enough tolerances) or can be glued.
No supports required. No bed adhesion modifiers necessary. Prints beautifully in standard .20mm layer heights using about 200g of PLA over a 4hr 45m print time on my K2 Plus.
No supports required. No bed adhesion modifiers necessary. Prints beautifully in standard .20mm layer heights using about 200g of PLA over a 4hr 45m print time on my K2 Plus.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
