Slicer Discord
Snapvine – 3D-Druckmodell von Thingiverse Thingiverse

Snapvine

von LennyFace
13 Downloads
9 Likes
0 Makes
Zum Modell
Snapvines are carnivorous plants found in Snapvine Bridge.

There are five Snapvines in the Campaign and Heroic Challenge modes of Snapvine Bridge. They are initially passive and do nothing until they awaken. The first Snapvine wakes at the start of wave two, and a further inactive Snapvine wakes every following two waves, until wave ten, in Campaign mode.

In the Heroic Challenge, one Snapvine wakes on every wave. Snapvines do not appear in the Iron Challenge.

Every wave, whenever a unit (friendly or enemy) stands in front of a Snapvine, it will eat that unit (and all units standing in a line from it, in the same lane), instantly killing them. Enemies killed by Snapvines still give gold.

Snapvines cannot eat Gorillons, Ashbite or Bonehart. Snapvines do not manually target Giant Wasps but can still swallow them when they stand in the same line with other units.
Tips & Tricks

When using melee heroes, pay attention to where he/she is going when fighting foes. It is easy for
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen