Thingiverse
Snowflake
by diybaron
1
Downloads
1
Likes
0
Makes
Print two of these and then slide them together for a 3D snowflake. Makes a great Christmas tree ornament.
After printing you may need to clean up the slot where the two will slide together in order to get the best fit. A piece of sand paper or an exacto knife should do the trick.
After printing you may need to clean up the slot where the two will slide together in order to get the best fit. A piece of sand paper or an exacto knife should do the trick.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
