Thingiverse
Snowflake
von diybaron
1
Downloads
1
Likes
0
Makes
Print two of these and then slide them together for a 3D snowflake. Makes a great Christmas tree ornament.
After printing you may need to clean up the slot where the two will slide together in order to get the best fit. A piece of sand paper or an exacto knife should do the trick.
After printing you may need to clean up the slot where the two will slide together in order to get the best fit. A piece of sand paper or an exacto knife should do the trick.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
