Thingiverse

Snowflake

by DaveTea

14 Downloads

11 Likes

0 Makes

Not much of a remix, I just fixed the stl so it is manifold, should print well with all slicers. My initial print (pictured) was done at 90MM/s with 10% infill and 0.2 layer. Came out pretty well considering I am using some cheap Chinese PLA that has been sitting in open air for over a year....it has some moisture in it ;)

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format