Sofirn Q8 Pro - Base End Cap

I needed a way to raise the Sofirn Q8 Pro up so the aftermarket handle I purchased would not hit the ground when the light was tailstanding. I printed this in TPU so it acts as a protective bumper for the bottom of the light. The cover fits loosly enough that it can be easily be removed. Scaling the cap down a bit should allow for a tighter, more permanent fit, although I haven't done this myself yet. Designed in OnShape if you'd like to make any changes:Sofirn Q8 Pro Accessories - OnShape Part of the Sofirn Q8 Pro Accessories Collection