Thingiverse
Sofirn SP31 Diffuser
von sescobar04
6
Downloads
3
Likes
0
Makes
Diffuser for Sofirn SP31 (or any other light that is roughly 23.4mm in diameter). Needs to be printed in translucent TPU to work properly.
I used 40% gyroid infill with 5 perimeters. I printed this in generic 85a TPU.
Needs to be printed with the closed end touching the buildplate. I didn't change the orientation before uploading.
I used 40% gyroid infill with 5 perimeters. I printed this in generic 85a TPU.
Needs to be printed with the closed end touching the buildplate. I didn't change the orientation before uploading.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
