Thingiverse
Solid Bed Mount
von jagoan
8
Downloads
6
Likes
0
Makes
It's just a 20mm tube?!!
Yes, yes it is. If you have z-probe sensor up and running, I highly recommend replacing your spring mount to this. This way, you remove the spring as a variable. The bed will be as level as the table your printer is sitting on.
You can adjust the height directly on your slicer. I made it 20mm because I have 10mm bed insulation on the way. I'd like a bit more clearance from the bracket.
Print 4 of this. ABS is ideal, or anything that can handle the maximum heat you plan for your prints.
Yes, yes it is. If you have z-probe sensor up and running, I highly recommend replacing your spring mount to this. This way, you remove the spring as a variable. The bed will be as level as the table your printer is sitting on.
You can adjust the height directly on your slicer. I made it 20mm because I have 10mm bed insulation on the way. I'd like a bit more clearance from the bracket.
Print 4 of this. ABS is ideal, or anything that can handle the maximum heat you plan for your prints.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
