Thingiverse
Solid cover, antenna mod - uConsole
von Kirouh
9
Downloads
16
Likes
1
Makes
Updated !
——-
The V2 can be clip-on on the back of the uConsole, using the stand as a support.
——
This is a solid uConsole cover, printed in PLA, and an antenna mod to improve WiFi reception (just applied with double face tape).
——-
Print settings :
PLA
0,2mm layers
15 - 20% infill
About 4~5h to print.
——-
The V2 can be clip-on on the back of the uConsole, using the stand as a support.
——
This is a solid uConsole cover, printed in PLA, and an antenna mod to improve WiFi reception (just applied with double face tape).
——-
Print settings :
PLA
0,2mm layers
15 - 20% infill
About 4~5h to print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!