Thingiverse
Solid State Relay Case (x4)
von nelsonii
2
Downloads
3
Likes
0
Makes
A case for holding a 4 relay board (solid state relays) along with mounts for USB power in and out (daisy chain). Triggered by simple switches via 1/8" (3.5mm) mono jacks (stereo okay).
You may need to flip the pieces in your slicer. Top should be 180 Y flipped -- just make sure flat side is down, and you're fine.
All parts off of Amazon. See https://github.com/nelsonii/SSR8-CAP1188 for the 8 port version -- same idea -- except the 8 port is much "smarter".
Fritzing to come. If you need help wiring, PM me.
You may need to flip the pieces in your slicer. Top should be 180 Y flipped -- just make sure flat side is down, and you're fine.
All parts off of Amazon. See https://github.com/nelsonii/SSR8-CAP1188 for the 8 port version -- same idea -- except the 8 port is much "smarter".
Fritzing to come. If you need help wiring, PM me.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!