Solid State Relay Hang Bracket - A8 - I3 Clone Printer

Bracket is designed to fit above the power supply without screws. It clips on the side and slides down. It uses the shape of the side support to hold it to the printer. The screw heads are counter-sunk. An air channel is designed behind the relay to allow for heat dissipation and it has been tested for 2 hour prints with no issues. If heating develops, the SSR can be flipped, with the internal heat sink (metal part) facing out. In extreme cases, the factory heat sink can also be added.

This mounting location allows the SSRs to be easily fed off the power supply. Both the hot end and bed wires were able to reach the location without issue.