Thingiverse
Sonic Pad Mount
di kfaubel
4
Download
7
Likes
0
Makes
## Overview
I wanted to mount my Sonic Pad in the same place as the old panel on my Ender 3 S1 Pro and I came up with this. The rail itself screws onto the side of the printer in the 3 holes that the old panel used. The right and left brackets snap onto the rail and can be shifted to get the right fit. The brackets are only different in the recess for the screw head. The panel sits up high enough for the wires to clear the bracket and rails.
I replaced the USB cable with this [1.6 ft cable from Amazon](https://www.amazon.com/dp/B07PFHB3R4?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1). The 90 degree plugs keep it tucked out of the way.
## Printing
* Brim: Yes for the rail (flat end with screw holes lay on the print bed), brackets did not need a brim
* Material: I did mine with PETG (Overture PETG - Yellow). I suspect PLA would be fine.
* Supports: No
* Resolution: .2 mm
* Infill: 25%
I wanted to mount my Sonic Pad in the same place as the old panel on my Ender 3 S1 Pro and I came up with this. The rail itself screws onto the side of the printer in the 3 holes that the old panel used. The right and left brackets snap onto the rail and can be shifted to get the right fit. The brackets are only different in the recess for the screw head. The panel sits up high enough for the wires to clear the bracket and rails.
I replaced the USB cable with this [1.6 ft cable from Amazon](https://www.amazon.com/dp/B07PFHB3R4?ref_=ppx_hzsearch_conn_dt_b_fed_asin_title_2&th=1). The 90 degree plugs keep it tucked out of the way.
## Printing
* Brim: Yes for the rail (flat end with screw holes lay on the print bed), brackets did not need a brim
* Material: I did mine with PETG (Overture PETG - Yellow). I suspect PLA would be fine.
* Supports: No
* Resolution: .2 mm
* Infill: 25%
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
