Sonoff Touch Light Switch Gap Frames

Design ConceptWhen I coverted my old light switches with Sonoff's smart switches I was annoyed to see that the electrical box cavity was slightly bigger than this new switch or had ugly marks on the plaster still visible after installation.The older light switch covers were a bit larger than the new switches.PurposeI only own two types to use as reference: Sonoff T0US1C, T0US2C, T0US3C - same frame.Sonoff Touch US - less round and a little bigger.The primary purpose of these frames is to cover unattractive gaps or marks around touch switches. They add a decorative element to your home or office setting, integrating functional and aesthetic needs.Printing RecommendationsThe frames do not have clips. It's designed to just slide over the switch.I printed multiple testers to get it right, but I did find slight differences between printers and filament, even with the same settings & dimensions.PLA is good0.20mm Layer Height10% InfillNo SupportsAssembly InstructionsAlign the frame with the touch switch and press gently to set it in place. Ensure the corners are firmly attached and adjust as necessary for a perfect fit.