Thingiverse
Spanner Rack RH
von indy4x
10
Downloads
5
Likes
0
Makes
This is a spanner rack to hold combination spanners
It is designed to hold 6mm to 20mm combination spanners in 1mm increments
The spanners it was designed for are a mix of SnapOn and Kennedy Professional
It is designed to go in the right hand side of one of the draws in my roll cab
I also have a design for the centre and left hand side
It is designed to hold 6mm to 20mm combination spanners in 1mm increments
The spanners it was designed for are a mix of SnapOn and Kennedy Professional
It is designed to go in the right hand side of one of the draws in my roll cab
I also have a design for the centre and left hand side
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!