Thingiverse
Spinner Button concave
von MakerPez
14
Downloads
8
Likes
0
Makes
New button for 608 bearing spinners
Made with a concave top for better handling
Also has a .25mm lip on the bottom face which will prevent rubbing on the bearing seals
Print top-up with supports
Over time I've found this button can fall out when printed at 100%
Solution is to print at 101 / 102% to get a better fit
Made with a concave top for better handling
Also has a .25mm lip on the bottom face which will prevent rubbing on the bearing seals
Print top-up with supports
Over time I've found this button can fall out when printed at 100%
Solution is to print at 101 / 102% to get a better fit
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!