Thingiverse
Split Keyboard tiny "foldable" tent kit
von Bmads
4
Downloads
12
Likes
0
Makes
Foldable tent kit for split keyboards, such as ergodox, redox, helidox, etc.
Requires **velcro** or **magnets** in order to hold the keyboard in place!
The use of at least **2 Rubber/Silicon O Rings** per support/base is recommended.
**Use sandpaper to slightly adjust the printed pin diameter, or make it smaller before printing**.
A 2.5mm hex key can be used to release stuck pins or replace them if you prefer.
The source blender file is provided to allow for small tweaks.
Requires **velcro** or **magnets** in order to hold the keyboard in place!
The use of at least **2 Rubber/Silicon O Rings** per support/base is recommended.
**Use sandpaper to slightly adjust the printed pin diameter, or make it smaller before printing**.
A 2.5mm hex key can be used to release stuck pins or replace them if you prefer.
The source blender file is provided to allow for small tweaks.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
