Split Rock Lighthouse Hueforge

This is a Hueforge design of the iconic Split Rock Lighthouse in Minnesota on Lake Superior. You can scale the model but do not change the Z height. You can make it with or without an AMS by adding pauses to change the filament. If using a single AMS just set the first and last color the same and then swap them out after the first one is done. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 146.63x220mm in sizeYou may print at higher layer heights below the Base Thickness of 0.48mmThe Max allowed Thickness is 3.2mm and the Actual Thickness is 2.88mmFilaments Used: PLA+ Sunlu Black Transmission Distance: 0.6 PLA+ Sunlu Blue Transmission Distance: 4 PLA+ Sunlu Red Transmission Distance: 6 PLA+ Sunlu Sunny Orange Transmission Distance: 8 PLA+ Sunlu White Transmission Distance: 5This print uses 5 unique filamentsSwap Instructions: Start with Black At layer #10 (0.88mm) swap to Blue At layer #16 (1.36mm) swap to Red At layer #22 (1.84mm) swap to Su