Thingiverse
Spool Holder
von SquirrelMan0705
0
Downloads
0
Likes
0
Makes
This is a spool holder for any printer, this could be stuck onto the wall or on the table.
I am afrade it will be very dificult to 3d print because of all the holes inside it.
This design was susposed to be injection molded.
I am afrade it will be very dificult to 3d print because of all the holes inside it.
This design was susposed to be injection molded.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!