Thingiverse
Spool Screw
von ThePrintSurgeon1
5
Downloads
2
Likes
0
Makes
The spool screw was designed to be a universal insert to save cost and waste.
I found that I was wasting a lot of filament spools and spoolless filament is often cheaper. So I designed this simple insert instead of buying a reusable spool.
Simply cut an empty spool in half, measure the inner diameter and scale to the right size. The pieces press into place. I tried to make the tolerances forgivable but you may need to print the screw 1-3% smaller.
I found that I was wasting a lot of filament spools and spoolless filament is often cheaper. So I designed this simple insert instead of buying a reusable spool.
Simply cut an empty spool in half, measure the inner diameter and scale to the right size. The pieces press into place. I tried to make the tolerances forgivable but you may need to print the screw 1-3% smaller.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
