Thingiverse
Spotify Controller Base
von ims5454
0
Downloads
0
Likes
0
Makes
PSU IEEE Spotify Controller Base
For this project, I bent back the pins on the display and added some pieces of tape between the display and ESP8266 module for support
There is a version with and without holes
I am currently designing a top case that fits overtop of the PCB that will be screwed in with the holes, but that is still being worked on. I'll link it here once/if I finish it.
There is no hardware holding in the Spotify controller. It just sits in the cutout.
For this project, I bent back the pins on the display and added some pieces of tape between the display and ESP8266 module for support
There is a version with and without holes
I am currently designing a top case that fits overtop of the PCB that will be screwed in with the holes, but that is still being worked on. I'll link it here once/if I finish it.
There is no hardware holding in the Spotify controller. It just sits in the cutout.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!