SpringBee

Small Bee with a springy body   Optional models for a multicolor print ---   If you want to sell prints of this model write to me, I can prepare a commercial licensed version   Short Video: https://www.instagram.com/reel/DYExaRqNATh/   --- Printing tips Printed with 0.16 and 0.2 layer height 2-3 walls No supports needed Some infill may be usefull (7-10%) Arachne wall generator NOT recommended (use Classic instead) - it makes some ugly lines on top in few places   May be harder to print than typical models You will need a good bed adhesion and a good cooling You may be needed to separate spring coils from each other after a print. Usually just with your finger nails, in some more rare cases with a thin knife (scalpel) It mostly depends on your seam settings and filament stringing   MULTICOLOR Select SpringBee and all of MULTI files, then drop them in slicer, merge together and select color for each part Multicolor files are with a 'frame' that helps with models aligning DO NOT try to 'repair' the models - frame will not be printed and it's not causing any problems with slicing   Tips if the model is breaking Filament should be dry and with good self adhesion Printing with wet filament will make the model more brittle (especially PLA) and model may break when stretched Silk filaments (especially dual or tripple color) and the ones with particles (like 'marble') may not be a good option - but it all depends on the filament You can try printing it slower, bonds between layers should be stronger   ---