Thingiverse
ST-SB Split Version
door darkmagedesigns
1
Downloads
0
Likes
0
Makes
**From Justin**
These are UFS sole plates for the Salomon ST series boots.
These soles require the middle bottom of the boot to be totally flattened. If you're a Salo purist then these are not the soles for you. #dontsavethenubsiftheymakeskatinglessfun
Sizes 25-26.5 and 27-28.5 available. More sizes coming eventually, someday, maybe never.
**From Me**
These are for the 27-28.5 boot. I split the STLs in MeshMixer so they can be printed on a 200x200mm print bed. Some sanding is required on the inside of the back plate on the positive side, behind the royal groove, to avoid the plate lifting at the split.
These are UFS sole plates for the Salomon ST series boots.
These soles require the middle bottom of the boot to be totally flattened. If you're a Salo purist then these are not the soles for you. #dontsavethenubsiftheymakeskatinglessfun
Sizes 25-26.5 and 27-28.5 available. More sizes coming eventually, someday, maybe never.
**From Me**
These are for the 27-28.5 boot. I split the STLs in MeshMixer so they can be printed on a 200x200mm print bed. Some sanding is required on the inside of the back plate on the positive side, behind the royal groove, to avoid the plate lifting at the split.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!