Thingiverse
Stackable 18650 Holder
von Smily1357
103
Downloads
59
Likes
1
Makes
This is a 18650 battery cell holder based on the design of https://www.thingiverse.com/thing:1004996 by adoniram.
It holds up to 10 cells and has the same height as this AA No-Jam Remix https://www.thingiverse.com/thing:1823580 by matn1.
It is wide enough to fit cells with integrated protection circuitry. (as seen in the picture)
Hints:
-The base needs some support
-The label has to be glued to the front of the cover.
-To put the back of the base and cover together I recomment useing a flat-head srewdriver
to bend the cover.
It holds up to 10 cells and has the same height as this AA No-Jam Remix https://www.thingiverse.com/thing:1823580 by matn1.
It is wide enough to fit cells with integrated protection circuitry. (as seen in the picture)
Hints:
-The base needs some support
-The label has to be glued to the front of the cover.
-To put the back of the base and cover together I recomment useing a flat-head srewdriver
to bend the cover.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
