Thingiverse
Stackable baskets
von vivamus3d
392
Downloads
304
Likes
0
Makes
Update-2022-03-04: After the surprising success of [version 2 of these baskets](https://www.thingiverse.com/thing:5156678) (full baskets, all sides with honeycombs), I decided to create a compromise between the two and called it "version 1b". The main difference to v1 is the angled front, which now has honeycombs (like v2), but I kept the closed bottom, so that nothing can fall through. And with the right Slicer settings they do not even need more filament than version 2. (see below)
----
Yet another set of stackable containers. You can find several different sets of stackable boxes on thingiverse, but many of them are for very small things only or use quite a bit of filament, so the DIY variant isn't much cheaper than buying some boxes.
Therefore I was looking for a compromise between size, stackability and minimal use of filament - stackable baskets of reasonable size. The largest one (30cm x 10cm) need only 100g of filament and of course no support. An due to the honeycomb
----
Yet another set of stackable containers. You can find several different sets of stackable boxes on thingiverse, but many of them are for very small things only or use quite a bit of filament, so the DIY variant isn't much cheaper than buying some boxes.
Therefore I was looking for a compromise between size, stackability and minimal use of filament - stackable baskets of reasonable size. The largest one (30cm x 10cm) need only 100g of filament and of course no support. An due to the honeycomb
vivamus3d veröffentlicht auch auf
17 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!