Thingiverse
Stackable Bed Riser
door kperkins1982
12
Downloads
8
Likes
0
Makes
This is a stackable bed riser. I have a bunch of sinus congestion and decided to raise my headboard. However I don't want it to feel weird. The plan is that I'll raise it a little bit with this but left some lego like holes on the bottom so that I can add parts to the bottom to raise it further in the future gradually getting to where I want it to be.
The bed rail sits inside the hole 25mm so it doesn't wobble out, and under that is 25mm of height. Roughly 1 inch. All beds are different so I included the fusion file so that the thing can be modified to fit different sizes.
The design could probably work with pla but if you can print with petg as beds are pretty heavy. Having said that I believe any more than 20 percent infill is a waste of material.
The sides are sloped on the left right and front to keep the bed from wobbling but not in the back so it can push flush to the wall.
There are a bunch of holes on the bottom for a couple reasons. One is to help it grip ca
The bed rail sits inside the hole 25mm so it doesn't wobble out, and under that is 25mm of height. Roughly 1 inch. All beds are different so I included the fusion file so that the thing can be modified to fit different sizes.
The design could probably work with pla but if you can print with petg as beds are pretty heavy. Having said that I believe any more than 20 percent infill is a waste of material.
The sides are sloped on the left right and front to keep the bed from wobbling but not in the back so it can push flush to the wall.
There are a bunch of holes on the bottom for a couple reasons. One is to help it grip ca
kperkins1982 publiceert ook op
32 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
