Thingiverse
Stackable box
von panzatros
0
Downloads
1
Likes
0
Makes
A simple and practical stackable box system that assembles easily.
Print as many “middle” sections as you want to make the box taller!
Files included (3 STL files):
bottom box.stl
mid box.stl (stack as many as needed)
box lid.stl
Printing info:
Tested and printed successfully with both 0.4 mm and 1 mm nozzles
All overhangs are 45° → no supports required
0.2 mm tolerance built-in for a perfect snap-fit – no sanding required!
Works great with standard PLA/PETG settings
Warning!: The side walls were te dovetail fits may be a bit on the thin side, so I may improve later.
Perfect for organizing small parts, screws, electronics, or anything you want to stack and protect!
Just print, snap together, and stack!
Print as many “middle” sections as you want to make the box taller!
Files included (3 STL files):
bottom box.stl
mid box.stl (stack as many as needed)
box lid.stl
Printing info:
Tested and printed successfully with both 0.4 mm and 1 mm nozzles
All overhangs are 45° → no supports required
0.2 mm tolerance built-in for a perfect snap-fit – no sanding required!
Works great with standard PLA/PETG settings
Warning!: The side walls were te dovetail fits may be a bit on the thin side, so I may improve later.
Perfect for organizing small parts, screws, electronics, or anything you want to stack and protect!
Just print, snap together, and stack!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
