Thingiverse
stackable Cone
von EugeneVanDerMill
5
Downloads
5
Likes
0
Makes
Einfach ein paar Verkehrs-Hütchen für... naja was man halt damit machen möchte, Ich plane damit einen Skate-Slalom aufzustellen.
Sie sollten sich stapeln lassen.
Just simple Traffic-Cones... for what you want to use them... I'm planning to use them in a skate-slalom.
They should stack
Gedruckt mit einer hohen Infill-Einstellung für eine schwerere Basis, der Kegel selbst ist nur 1,2mm, also mit drei Drucklinien.
Printed with a high Infill-setting to get a heavier Base, the cone is just 1.2mm so it prints with just three lines.
Sie sollten sich stapeln lassen.
Just simple Traffic-Cones... for what you want to use them... I'm planning to use them in a skate-slalom.
They should stack
Gedruckt mit einer hohen Infill-Einstellung für eine schwerere Basis, der Kegel selbst ist nur 1,2mm, also mit drei Drucklinien.
Printed with a high Infill-setting to get a heavier Base, the cone is just 1.2mm so it prints with just three lines.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!