MakerWorld
3D Printer Accessories
Go to Model
Stackable desiccant drying box
1.6k
Downloads
438
Likes
1.1k
Makes
This tray allows you to dry your renewable silicagel beads in your printer. Simply fill it with a thin layer of beats, set the printer to 55 Celcius and enable the chamber- and auxilery fan. Drying may take somewhere between an hour and 4 hours. This tray is also stackable!! After drying you can remove the corner of the tray to poor your beads back into the box that was holding them.
Sander also publishes on
53 additional models across 5 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
