Thingiverse
Gadgets
Zum Modell
Stackable HDD case
256
Downloads
181
Likes
0
Makes
Here is a stackable HDD case, suitable for 2,5'' hard drives, (12mm thickness or less).
No screws needed, each hard drive stays in place due to the friction with case walls.
I uploaded the original **FreeCAD** file, feel free to improve the design !
I just stacked 3 of them, I'm sure you can stack 2 or 3 cases more, with the applied offset. The offset make it easier the SATA-to-USB bridge I use to connect the hard drives.
Even if FreeCAD is a good parametric 3D software design, I had to repair the final model (Mesh mode in FreeCAD). STL file repaired provided.
Enjoy !
No screws needed, each hard drive stays in place due to the friction with case walls.
I uploaded the original **FreeCAD** file, feel free to improve the design !
I just stacked 3 of them, I'm sure you can stack 2 or 3 cases more, with the applied offset. The offset make it easier the SATA-to-USB bridge I use to connect the hard drives.
Even if FreeCAD is a good parametric 3D software design, I had to repair the final model (Mesh mode in FreeCAD). STL file repaired provided.
Enjoy !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
