Thingiverse
Stackable mini figure arena set
von BIGMANTOYS
6
Downloads
12
Likes
0
Makes
No supports needed, just skirt or brim. Easy.
Just print so all the little pegs are facing upwards.
It's not perfect. You might need to add tape to the pegs to make them snug depending on your print settings.
In order for the arena to fit around most mini wrestling rings, I recommend printing at 517mm on the longest plane.
Just print so all the little pegs are facing upwards.
It's not perfect. You might need to add tape to the pegs to make them snug depending on your print settings.
In order for the arena to fit around most mini wrestling rings, I recommend printing at 517mm on the longest plane.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!