Thingiverse
Stackable Planter
por phesketh01
52
Descargas
44
Likes
0
Makes
An excellent succulent planter with easier supported bottom and easier bridged top. No visual difference to the original aesthetic.
Excellent design - the original was just difficult to print with single extrusion lines ontop of support, and poor bridging if printed upside down.
This version negates all of that. Print with the bottom of the planter on the bed, supports set to from build platform only, and let the top bridge. It should bridge very easily with no support needed.
Excellent design - the original was just difficult to print with single extrusion lines ontop of support, and poor bridging if printed upside down.
This version negates all of that. Print with the bottom of the planter on the bed, supports set to from build platform only, and let the top bridge. It should bridge very easily with no support needed.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
