Stackable Spiral Mosspole

A mosspole for your aroids to climp on.

Since there weren't a lot of moss poles on Thingiverse and i didn't like the hexagon patterns in the existing poles, I tried to make my own one.

The poles are about 200mm long (+ a little) and 40mm in diameter.
You can print several sections and screw them together by the printed thread.

Be careful not to break the pole when screwing together! PLA is very brittle and the poles are very thin. Use some PTFE spray or WD40 on the thread to make it easier to assemble the poles. After all, they are more stable than I thought.

If you are using a light substrate for your plants, I suggest you don't use the spike. Instead, use wire to fixture the Pole on the drainage holes of your planter.

---

Printing Instructions:
*Calibrate your printing profile for overhangs and stringing!*
My first pole was terrible. After I lowered the printing temp. and retract I got a clean print.
The Threads use a 55° overhang. So that's a little more than 45° but you