Thingiverse
Stackable Sunlu Spool Drawer
von Leen15
2.3k
Downloads
2.1k
Likes
1
Makes
Hello,
this is a stackable drawer compatible with Sunlu spools.
You Just need to print 4 slots and make 4 holes in every spool.
Keep attention that every hole has to be aligned between spools if you want to stack them.
They are connected between 4 sticks that are used to both keep slots in place and also to stack spools.
At the bottom of first spool and at the top of last one you can use dedicated caps instead.
There is available also a base that allows spools to rotate.
this is a stackable drawer compatible with Sunlu spools.
You Just need to print 4 slots and make 4 holes in every spool.
Keep attention that every hole has to be aligned between spools if you want to stack them.
They are connected between 4 sticks that are used to both keep slots in place and also to stack spools.
At the bottom of first spool and at the top of last one you can use dedicated caps instead.
There is available also a base that allows spools to rotate.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
