Thingiverse
Stackable token trays
von jamardracken
2
Downloads
5
Likes
0
Makes
Original creator: https://www.printables.com/model/1040400-stackable-token-trays-set-updated
I remixed this model because I needed different sizes.
Printing is pretty straightforward, supports are not required but if you are not sure about your printer handling bridges you can add supports onb outer straight lines between 2 cups.
I remixed this model because I needed different sizes.
Printing is pretty straightforward, supports are not required but if you are not sure about your printer handling bridges you can add supports onb outer straight lines between 2 cups.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
