Thingiverse
Stand Tablet
von Gianluca411
3
Downloads
1
Likes
0
Makes
A stand for your tablet of about 10 inches.
Very resistant with an angle of about 30 degrees to facilitate the writing phase.
I recommend adding silicone pads in the paws to prevent slipping.
Very resistant with an angle of about 30 degrees to facilitate the writing phase.
I recommend adding silicone pads in the paws to prevent slipping.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!