StarTech Desk Mount
von Amberclad
3
Downloads
3
Likes
0
Makes
This is intended specifically for the StarTech TB3DK2DPPD and physically similar models. It can be used to mount the dock to the underside of a desk with two screws.
The first STL cannot be printed on an Ender 3, but has wider mounting points for the screws. The second STL file can be printed on an Ender 3, but at the cost of smaller screw mounting points.
The screw shaft diameter is 3.6mm and the mounting point thickness is 10mm.
The first STL cannot be printed on an Ender 3, but has wider mounting points for the screws. The second STL file can be printed on an Ender 3, but at the cost of smaller screw mounting points.
The screw shaft diameter is 3.6mm and the mounting point thickness is 10mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!