Thingiverse
Household
Go to Model
Sunlu PLA empty stackable & rotatable spool storage container
263
Downloads
771
Likes
2
Makes
I made an easy to print storage container from old plastic Sunlu spools.
There are different sizes spools so look out for these measurements.
- Diameter 195mm
- Inside Height 50mm
Just close the spool and slide the containter between the spool.
Use the bolt after each compartment to stack them.
Print Details:
- Both parts are constructed to be completely support FREE.
Container:
- Wall loops = 4
- Top Shell Layers = 5
I advise using these settings as The ring where the container turns on might break if it isn't reïnforced.
The wall loops make sure that part is a 100% Infill and the top shell layer is there for the rupture of the complete cilinder.
Rotating Knob:
- Nothing of special value
1/8/2025
Added The editable tag
There are different sizes spools so look out for these measurements.
- Diameter 195mm
- Inside Height 50mm
Just close the spool and slide the containter between the spool.
Use the bolt after each compartment to stack them.
Print Details:
- Both parts are constructed to be completely support FREE.
Container:
- Wall loops = 4
- Top Shell Layers = 5
I advise using these settings as The ring where the container turns on might break if it isn't reïnforced.
The wall loops make sure that part is a 100% Infill and the top shell layer is there for the rupture of the complete cilinder.
Rotating Knob:
- Nothing of special value
1/8/2025
Added The editable tag
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
