Sunset

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm  The Model is 200x200mm in size. You can change X and Y but Z must remain the same.  You may print at higher layer heights below the Min Depth of 0.48mm  Actual Depth is 2.3mm Filaments Used: PLA BambuLab Basic Red Transmission Distance: 4 PLA BambuLab Basic Orange Transmission Distance: 5 PLA BambuLab Basic Yellow Transmission Distance: 6 PLA BambuLab Basic Black Transmission Distance: 0.3 PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 5 unique filaments. Substitute as needed. Swap Instructions: Start with Red At layer #10 (0.88mm) swap to Orange At layer #11 (0.96mm) swap to Yellow At layer #13 (1.12mm) swap to Black At layer #21 (1.76mm) swap to Jade White for the rest.