Sunset

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 200x200mm in size. You can change X and Y but Z must remain the same.You may print at higher layer heights below the Min Depth of 0.48mmActual Depth is 2.3mm Filaments Used:PLA BambuLab Basic Red Transmission Distance: 4PLA BambuLab Basic Orange Transmission Distance: 5PLA BambuLab Basic Yellow Transmission Distance: 6PLA BambuLab Basic Black Transmission Distance: 0.3PLA BambuLab Basic Jade White Transmission Distance: 5This print uses 5 unique filaments. Substitute as needed. Swap Instructions:Start with RedAt layer #10 (0.88mm) swap to OrangeAt layer #11 (0.96mm) swap to YellowAt layer #13 (1.12mm) swap to BlackAt layer #21 (1.76mm) swap to Jade White for the rest.Boost MeGot a Boost to spare? Every little bit helps the motivation. Thank you!MembershipWant to go commercial or maybe just show some love? Consider signing up to show support!